Cementtiles

Storage and Installation Guidelines

  • Step 1

    Step 1

    After the tiles are transported to construction sites, before immediate use, they must be stored under the following requirements:
    + Ensure the tiles are kept in a dry, even and flat surface. Keep them away from water and free from dirts.
    + Only install the tiles in the last stage of construction. Clean the tiling surfaces after installation to avoid dirt adhering on the tiles. 
    + Tiles must be stored in sheltered area and carefully covered by fabric or plastic. It is the best to store the tiles in a proper storage area.

  • Step 2

    Step 2

    + Spread a layer of grout on the floor’s surfaces.
    + Uneven spreading will lead to breakage, usually at the 4 corners of a tile.
    + Then begin tile installation.

  • Step 3

    Step 3

    24 hours after completing installation, use grout cleaning powder of complemetary colors to the tiles or the diluted white cement

  • Step 4

    Step 4

    After diluting, use a hard piece of board to carefully rub on each line of grout

  • Step 5

    Step 5

    Clean the dirt right after every grouting.
    If the dirt is not cleaned right away, white marks will appear on the tile and it will be hard to remove in completion stage.
    Caution: Oil, coffee and cocoa stains should be cleaned within 1 hour

  • Step 6

    Step 6

    Once the layer of grout is dry, pour a large amount clean water onto tiled floor.

  • Step 7

    Step 7

    Use thin sandpaper to remove dirt on the surface.

  • Step 8

    Step 8

    Use clean cloth to carefully clean the floor and wait until the tiles are dry then start polishing (if necessary)
    Cautions: White marks will emerge if the grout is not completely removed from the surface.

  • Step 9

    Step 9

    Apply a thin layer of the provided wax onto the surface then wait for 2 minutes.
    Polishing if required
    Use the special purpose wax as provided to apply a thin layer onto the surface then wait for 2 minutes prior to polishing.
    Use clean and soft cloths to polish the surface until the patterns emerges.
    In order to shine the floor quickly, clean the floor with large amount of water multiple times a day.

  • Step 10

    Step 10

    Cautions after tile installation:
    + In order to ensure a high aesthetic appeal of the tiles, our company will polish the tiles prior delivery.
    + Do not use any kind of oil or bleach to scrub tiles’ surfaces.
    + In order to keep the floor shiny, the tiles should be cleaned with diluted soap (100g of soap/ 20 litres of water).
    + White marks will show up if the grout is not completely removed from the surface.